Welcome to the new version of CaltechAUTHORS. Login is currently restricted to library staff. If you notice any issues, please email coda@library.caltech.edu
Published November 15, 2014 | Accepted Version
Journal Article Open

Cathodic regeneration of a clean and ordered Cu(100)-(1×1) surface from an air-oxidized and disordered electrode: An operando STM study

Abstract

In work related to the electrocatalysis of the CO_2 reduction reactions, we recently reported in This Journal the structure and composition of a Cu(100) electrode surface, pre-dosed at low levels of O_(2(g)) to simulate a Cu electrocatalyst unprotected from air, before and after immersion in alkaline electrolyte at fairly negative potentials to ascertain if an oxide-to-metal reduction reaction can be effected; experimental measurements were based upon ex situ techniques, low-energy electron diffraction (LEED) and Auger electron spectroscopy (AES). It was found that the mildly oxided surface remained ordered and could be cathodically reduced back to a well-ordered oxide-free Cu(100); the quality of the LEED pattern and AES spectrum was less than ideal, however, due to small amounts of base electrolyte remnant in the emersed layer. In this Short Communication, we present results from operando electrochemical scanning tunneling microscopy (EC-STM) that not only confirm the earlier observations but, more importantly, depict more accurately the actual electrocatalysis conditions. An as-received commercially oriented Cu(100) disk that had not been protected from air was observed to consist of narrow terraces encrusted with highly disordered oxides. Cyclic voltammetry and coulometry showed that the oxidized surface consisted of five monolayers of CuO and quarter of a monolayer of Cu_2O. Upon complete cathodic reduction of the interfacial oxides, the surface was found to have reverted to a single-crystalline Cu(100)-(1×1) structure. It may thus be inferred that, under the conditions of electrochemical CO_2 reduction, the Cu catalyst would exist as a zerovalent metal.

Additional Information

© 2014 Elsevier B.V. Received 2 August 2014, Accepted 9 September 2014, Available online 19 September 2014. This material is based upon work performed by the Joint Center for Artificial Photosynthesis, a DOE Energy Innovation Hub, supported through the Office of Science of the U.S. Department of Energy under Award No. DE-SC0004993. There is no conflict of interest among the authors.

Attached Files

Accepted Version - Kim_2014.pdf

Files

Kim_2014.pdf
Files (2.3 MB)
Name Size Download all
md5:f43b30008d12affdb2d437c3a796c2c2
2.3 MB Preview Download

Additional details

Created:
August 22, 2023
Modified:
October 17, 2023